Partner Sites
BEML Previous Paper
1. The very essential desired property of an measuring instrument is....
2. Precision is defined as ...
3. CPM is the technique of...
4. Value Engg is the study of..
5. In a press work, the size of the hole pierced is dependent on the...
6. Trimming is associated with...
7. Rivets are made of........materials
8. The decrease /absence of toughness of a material implies that the material is ....
9. The property of material by which it can be beaten into plates is called....
10. Type of chips produced while machining Cast iron are....
11. Bearings which require no lubrication are called....
12. Blades of Gas turbine are made up of.....
13. Crater wear occurs on.....portion of tool
14. Gears used to transmit power from non parallel and non intersecting shafts.......
15. The general gas equation is ...
16. The change of entropy depends on....
17. With 100% relative humidity, the wet bulb temp...(With regard to dew point temp)
18. SI Unit of temperature....
19. Unit of Young's modulus....
20. Property of fluid which offers resistance against Tensile stress...
21. Mercury do not wet the glass, this is because of.....
22. Which law states that Specific heat is constant at all temp and pressures...
23. The gear box in an automobile is located between....
24. The welding process which uses a consumable Electrode......
25. Steel balls are produced by....
